Pro Install Kit | Spray Bottle, Squeegees, Microfiber, Heat gun and more

Make installation easy with our Pro Install Kit! It comes with all the tools you need for a successful installation.

What's Included

• Electric spray bottle - use for slip solution. Mix clear liquid soap or baby shampoo in about 1:200 ratio for PPF and 1/10 ratio for window tints.Spray the adhesive side of the film with the slip solution before applying.
• Manual pump sprayer - use for tack solution. Clean water or if you are having issues with adhesive you can mix 99% IPA with clean water in 1/3 ratio.
• Large rubber squeegee - this is the main squeegee you will need for PPF and window tint. Use it to remove the water from under the film after applying.
• Small plastic squeegee - use for tucking in and edges, areas where the film needs more pressure than the rubber squeegee can provide.
• Small rubber squeegee - use itthe same as the large rubber squeegee, for harder to access areas.
• Heat gun - use it to warm up the PPF to make it conform to edges and stick better.
• Microfiber - use for soaking water when you are squeegeeing up, working against gravity and the water goes right back under the film.
• Knife - use it to trim excess PPF if you end up with it.
• Weeding tool - use it to pick up PPF from hard to reach areas, usually helpful when doing edge folding and you want to redo a certain area but can't reach the PPF.
• Orange edge tool - use it to tuck PPF around hard to reach edges.
• Yellow edge tool - use it to tuck PPF under other plastic trims, such as headlights, fenders etc.
• Diabetic needle - use it to extract water or air bubbles that appear post installation.